[Pw_forum] stress units

Stefano Baroni baroni at sissa.it
Fri Feb 6 09:50:52 CET 2004


Paul is right, but the one who wrote the output format is probably not 
wrong.
The situation is confused in the literature 1: Ry and 1 Har are equally 
called 'one atomic unit' of energy.
I suggest to explicit distinguish between "Hartree atomic units" 
(e=\hbar=m=1) and "Rydberg atomic units" (e^2/2=2m=1) and to clearly 
state which one of the two "atomic units" is being used.
Stefano B.

On Feb 6, 2004, at 6:06 AM, Paul Tangney wrote:

> Dear Pwscf users/developers,
>
> This is a minor point, but one that should probably be fixed at
> some stage....
>
> In the output of pwscf the stress is printed out in units
> of Ryd/(au^3), but it is stated that it is in atomic units.
> I forget about this factor of 2 error from time to time
> and run into problems......it just happened again, and this
> finally motivated me to point it out.
>
> Best regards,
>
>
> Paul Tangney
>
>
>
>
>
>
>
> OoOo-------------------------------------------------------------
> University of California at Berkeley   /    Phone : (510) 642-2635
> Physics Department #7300       /       Home Phone : (510) 883-1259
> 366 Le Conte Hall             /               Fax : (510) 643-9473
> Berkeley, CA 94720       /      Email : tangney at civet.berkeley.edu
> Home page : http://civet.berkeley.edu/tangney/
> -----------------------------------------------------------------
>
>
>
> _______________________________________________
> Pw_forum mailing list
> Pw_forum at pwscf.org
> http://www.democritos.it/mailman/listinfo/pw_forum
>

---
Stefano Baroni -- SISSA & DEMOCRITOS National Simulation Center
via Beirut 2-4 34014 Trieste Grignano / [+39] 040 3787 406 (tel) -528 
(fax)




More information about the Pw_forum mailing list